ENGINEERING MECHANIC - EXAMPLE 15.1 : What is the meaning – strain? In a distillation column, if a block 10 cm on a side is deformed so that it becomes 9 cm long, what is the strain involved in percentage?
1 1544BIOPROCESS ENGINEERING - EXAMPLE 14.3 : The kinetic behavior of an enzyme could be described using Michalis - Menten equation : Vo = Vmax [S] / (Km + [S]). Derive this equation from [ES] = [E]total [S] / (Km + [S]), Vmax = Kcat [E]total, Vo = Kcat [ES].
1 1786ENGINEERING MECHANIC - EXAMPLE 15.2 : A cantilever beam of length L = 3 m carries a uniformly distributed load (UDL) of W = 20 N / m throughout the length. Calculate the bending moment, BM of the beam near the fixed end. What is the shear force, SF at this point? Let SF = -WL, BM = -LWL/2.
1 1466ENGINEERING MECHANIC - EXAMPLE 15.3 : A biochemical trolley of mass 15 kg is towing a trailer of mass 5 kg along a straight horizontal pathway. The trailer and the trolley are connected by a light inextensible tow-bar. The engine of the trolley exerts a driving force of magnitude 100 N. The trailer and the trolley experience resistances of magnitude 10 N and 30 N respectively. (a) Form 2 equations with unknowns T and a, that represents the equilibrium for the 2 systems of the trolley and trailer. (b) Solve the simultaneous equations from the 2 equations that are obtained in part (a) of this question. T is the tension of the tow-bar and a is the acceleration.
1 1404Question 105 - In a rigid rotor model in quantum chemistry, the moment of inertia I is given by an Equation E as I = Ma x La x La + Mc x Lc x Lc = m x L x L, where m = (Ma x Mc) / (Ma + Mc) and L = La + Lc, m is the reduced mass, Ma is the mass of a, Mc is the mass of c, La is the radius of a from point O, Lc is the radius of c from point O. Prove by simplest method that Equation E is wrong.
1 1896Why we need to maintain furnace and secondary air dp.if it increase or decrease what happens.
1 8562ELECTRICAL TECHNOLOGY - EXAMPLE 16.1 : According to Shockley equation, the I - V characteristic of a diode is approximated by I = IS [ exp (nVD / VT) - 1 ]. For silicon, let the reverse bias saturation current IS as 0.000000000001. If n is ideality factor with value of 1.5, VT as thermal voltage drop of 0.026 V at room temperature, what is the value of current I that passes through the silicon diode in the heater of evaporator when the forward voltage drop VD = 0.026 V? Please take note that exp is the exponential function with e(1) = 2.718, e(2) = 7.389.
1 1629ELECTRICAL TECHNOLOGY - EXAMPLE 16.2 : In a selection of suitable heating equipment for drying of crystals of biochemical, the one of the lowest current consumption will be chosen for safety consideration. Selection is available : (A) 120 V microwave oven 1800 W. (B) 240 V conventional oven 11000 W. Which one should be chosen and why?
1 1400COMPUTER PROGRAMMING FOR ENGINEERS - EXAMPLE 17.1 : By using Excel or other easiest programming package, explain how I, the integral of sin x dx from 0 to 3.142 could be approximated using random number. Find the exact value of I.
1 1753ELECTRICAL TECHNOLOGY - EXAMPLE 16.3 : In the design of a solar power system steps of calculations below are followed : (a) The power output of the inverter of the solar panel is 100 watts. What is the power input, Pin to the inverter when the efficiency of the inverter is 50 %? (b) If the rated power of the inverter is 300 watts, how many inverter is needed for the solar panel? (c) Charge controller of V = 12 volts is used to supply power to the inverter. What is the input current I to the inverter? (d) If the charge controller capacity is 10 A, how many charge controllers are needed? (e) If a biochemical mixer consumes 100 watts, running for 2 hours per day, what is the energy consumption in kilowatt hour per day? (f) What is the input energy needed when the efficiency of the inverter is 50 %? (g) If your area receives 2.88 hours of full sunlight per day, how much energy, in kilowatt hour can be produced per day when one solar panel can produce 20 watts of power? (h) If you know that you have to produce total energy as the answer for (f), how many solar panels are needed? (i) Each V = 12 V battery has 5 ampere hours. If the total energy needed is in answer (f), then how many batteries are needed to run the biochemical mixer if without sunlight for 3 days?
1 1713Question 104 - In photoelectrical effect analysis of quantum chemistry, let E = kinetic energy of electron, p = intensity of UV light, f = frequency of UV light. According to Classical Theory, E = c for all values of f, E = mp. According to Quantum Theory, E = c for all values of p, E = mf + c. In a graph, m and c are constants where m is slope and c is y intercept. If m = 2 and c = 3 with similar value of E : (a) find the value of p according to Classical Theory; (b) find the value of f according to Quantum Theory.
1 2157
W.A.P to take input of an array and display the entered no. in dos.
Describe the typical workflow of a production engineer from product design to final manufacturing.
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
what is the permanent solution applied for restoration of leaning tower of pisa?
What is difference between engineering stress and true stress?
What is the method of determining maximum differential pressure during hydro testing of shell and tube heat exchangers?
What experience have you had in working with field forces?
Where is mangenese steel used?
what is PWM in IGBT and how it works for drive.?
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
what are the test requirment fot protocol testing (for SS7,SIP)
Explain what is zoning permit?
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
Is cnc operating experience is must for successful career in cad/cam?How to make salary jump in this field of cad/cam?
How much percentage of brick bats allowed in CD-75 bricks