1 Cubic Meter = 487 Modular Brick, 1 Cubic Meter = 494 Non Modular Brick, (As per Rate Analysis DSR 2012 Vol.-1)what is the Brick Size ? 1 Cubic Feet = 13 Modular Brick, 1 Cubic Feet = 17 Non Modular Brick. what is the Brick Size ?
2 8143Used Cement Mortar, Cement & Sand in 1 Square Meter or 1 Square Feet For 10-18mm Thick Plaster ? (1:6) (1:4)(1:3)
3 9736In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
PCE,
1618We use MCCB not MCB for motor starters because MCCBs has capablity to drawout the motor starting current which is 5-6 times the full load current of motor for 1sec. Then why we use SDF in starter panel means MCC panels. Pls reply if any one knows this answer.
1 1952we are provide groove at sides of door & window frames, columns & beams any water dampness & seepage in external side? explain it
1 3595In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
1488After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
1478
What problem arise if we use regulators without/before filters?
Does the direction of rotation of d.c. Shunt motor would get reversed if the armature current and field current both are reversed?
minimum number of bars in a beam? minimum and maximum column size and beam size ? minimum and maximum aggregate size used in multistorey residential building for columns,beams,slabs?
what is POTT and PUTT explain?
PLZ EXPLAIN THE INTERLOCKING AND CONTROLLING OF CONTACTORS????HOW CAN I DO THAT?
What are the disadvantages of axial flow (piston type) automatic control valve compared to the conventional types (globe or diaphragm) If you are a designer/specifier, do you accept this type of valve for using in building's piping systems ?
i am preparing for motor vehicle assistant inespector please send me old questions papers.
What is maximum continuos Rating?
What is a good method of steam tracing large vessels?
What are the uses of windmill?
What is frog testing? What is cone model?
in regenrative cycle why to use two liquid(water&mercury) on steam genration cycle.
what is reactive power?, why its measured in VA ? is it transient behavior of system?
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
What is the most important thing you have achieved as an engineer?