Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) Any one can explain if there is any harm from humming noise heard from air circuit breaker : we have 415 switch board having two incomers from transformers 3.3KV/415V , when bus coupler closed, and open one ACB incomer to work in one of the transformers, the current started hunting around 50 Amps, and heard humming noise from the air circuit breaker, although the load current was only 1200 amps while the ACB capacity is 2500 Amps, and the transformer 1600 KVA. The same didn't happen when taken the other transformer offline. Why this humming noise and current fluctuation? is there any implication or danger, bearing in mind that we just returned everything back to normal and stopped the maintenance of the transformer. Shall we go ahead and ignore this noise?
6 12938
Will water damage concrete?
WHAT IS MOBILE SUB-STATION? & REALLY BENEFIT IN INDIA
Two initially identical samples A and B of pure germanium are doped with donors to concentrations of 1*10, 20 m-3 and 3*10, 20 m-3 respectively. If the hole concentration in A is 9*10 12 m-3, then the hole concentration in B at the same temperature will be
Explain what is a state table?
How long does it take concrete to harden?
write down the formula of cable size in RM if current is 50Amp.
in ranking cycle why steam is condenset in condensor
Why is better to have a minimum ceiling voltage of 250% than 160%?
why ups rating in kva? and why ups are in parellel?.why isolation transformer is used in ups?
Why does a compression engine use high –octane fuel?
State angle criterion.
how to calculate the loss tangent of electrical cables
draw 3 phase rectifier diagram
How to calculate chejja reinforcement
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?