hi friend i am stuck in the big problem.this problem is
regading pix firewall. i have a cisco pix 515e firewall
inmy company.now when i configure it and after rebooting it
the ACT link never getup.when i apply clear config all
comand the ACT link get up after oveservation i see that
there is fauilover problem
when i apply failover active ACT link agin get up
is there any way to get my firewall in standby mode
rember that there is only on firewall within my n/w
i am lookig towards all of you
jitendera kumar sinha
- 0 Answers
- 1490 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
Identify the 2 commands that copies the configuration in NVRAM to RAM? A.) copy backup-config running-config B.) configure nvram C.) copy startup-config running-config D.) configure memory
Explain the difference between routable and non- routable protocols?
What is Data, management, native, default,trunk and access vlan?
What is required to support full-duplex Ethernet? A.) Multiple paths between multiple stations on a link B.) Automatic sensing operation by all connected stations C.) Loopback and collision detection disabled D.) Full-duplex NIC cards
When setting up a frame-relay network between a Cisco router and a non-Cisco router, what encapsulation type should you use? A.) SAP B.) CISCO C.) IANA D.) Apollo E.) IETF F.) Q933A
What is the difference between bus topology and hub?
Which router component stores routing tables APP cache and packet buffers? A. ROM B. RAM C. AVRAM D. Flash memory
The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full
How much hold down time of eigrep protocol?
Hi Jitendera, I continuously read your answers which is more knowlegable than books... Q.I am facing some problems in subnetting.can you plzz explain the subnetting process.. will be remain thankful
What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message
If you are in IOS user mode, which command do you use to enter the privileged mode? A. Set B. Enable C. Configure D. Privileges
CCNA 
