How many valid host IP addresses are available on the following network/subnetwork? 176.12.44.161/30 A. 2 B. 30 C. 254 D. 16,382 E. 65,534

4 Answers   Cisco,

---

what is internetworking.

6 Answers  

---

Which three basic switch functions increase available bandwidth on the networks? (Choose three) A. loop avoidance B. address learning C. hop count limiting D. broadcast filtering E. packet forward/filtering F. broadcast packet hop count learning/forward/filtering

1 Answers  

---

A router blocks ___________ Broadcasts Unicasts All packets Nothing

1 Answers  

---

Explain why is udp lease favored when compared to tcp?

0 Answers  

---

What is 10base5 ethernet lans?

0 Answers  

---

Can we write any script for router to instruct that from where it will boots e.g. TFTP,FLASH...if yes what is it and how? 1 of my frnds says its possible...

3 Answers  

---

Scenario: You created 2 access-lists for controlling telnet about a year ago, and bound one of them to Serial 0. You can't remember which access-list you used. Which command lets you see all access-lists on Serial 0 for telnet? A.) show access-list B.) show ip int s0 C.) show access-list telnet D.) show telnet access-list E.) show access-list s0 F.) show int s0

2 Answers  

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

4 Answers  

---

What is a characteristic of Store and Forward switches? A.) They forward the frame before it is completely read. B.) They work at wire speed. C.) They are the same a Cut-Through switching. D.) They read the entire frame and check CRC before forwarding. E.) They decrease latency.

1 Answers  

---

What IP command would you use to test the entire IP stack? A.) Stack-test B.) Arp C.) Telnet D.) Ping E.) Trace

2 Answers  

---

What is the command to copy the IOS image to a TFTP server? A.) copy flash tftp B.) copy running-config tftp C.) copy ios tftp D.) copy startup-config tftp

2 Answers  

---