1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

What is the syntax of ipv4?

Question Posted / kaushal kumar


What is the syntax of ipv4?..

Answer / Maninder

An IPv4 address has four octets (8-bit segments), each represented by a number between 0 and 255. The syntax is usually presented as four numbers separated by dots, e.g., 192.168.1.1.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More CCNA Interview Questions

What is the difference between rip and igrp?

1 Answers  

Which OSI layer provides best effort end to end packet delivery? A.) Data-Link B.) Presentation C.) Network D.) Transport E.) Physical F.) Application

2 Answers  

Which of the following is an invalid host address using a netmask of 255.255.255.192? A.) 10.1.1.1 B.) 10.1.1.66 C.) 10.1.1.130 D.) 10.1.1.127

3 Answers  

What is trigger rip and from which ios version it starts?

1 Answers  

Can you explain PPP link process step by step?

1 Answers   CCIE, Sawes,

Which Cisco IOS command should you use to display the Novell IPX address assignments on a router? A. show ipx addresses B. show ipx interface C. show me the money D. ipx, network (number) E. display ipx addresses F. show ipx routing details

1 Answers  

what is the binary value of loop back address

13 Answers  

Mention what is the difference between dynamic ip and static ip addressing?

1 Answers  

what is internetworking.

6 Answers  

b Which protocol for PPP LCP (Link Control Protocol) performs a challenge handshake? A. CHAP B. PAP C. UDP D. IPX

1 Answers  

What is the maximum value of administrative you can use?

1 Answers  

hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

1 Answers   IBM,

For more CCNA Interview Questions Click Here
Categories