Interested to Buy Any Domain ? << Click Here >> for more details...
What is convergence time?
A.) The update time
B.) The time it takes to reload a router
C.) The time it takes for a packet to reach its destination
D.) The time is takes for all routers update their tables
after a change
takes place
- 2 Answers
- 11461 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: D
Convergence is slower for Distant Vector routing and is
faster for Link
State routing.
| Is This Answer Correct ? | 10 Yes | 2 No |
Answer / shahid
convergence is slower for distant vector and is
faster for link !we can use increasing time and decreasing time for send packet
| Is This Answer Correct ? | 2 Yes | 0 No |
What is an administrative distance of 0 mean? A.) 0 means unbelievable B.) 0 is for EIGRP C.) 0 is the default distance for directly connected networks D.) 0 means unreachable
What command would you use to find out the names of Novell servers on a network? A. show ipx servers B. show ipx hosts C. show ipx sap D. show ipx nodes.
how we update the IOS version with the help of TFTP?
What port does rip use?
Identify the purpose of ARP? A.) Avoiding routing loops B.) Determining a workstation's IP address C.) Sending a directed broadcast D.) Determining a workstation's MAC address
In STP the Root Bridge Sends the BPDU in Every 2 Sec,In BPDU What kind of Information is i.e. What kind of information BPDU Contains?
What is required to support full-duplex Ethernet? A.) Multiple paths between multiple stations on a link B.) Automatic sensing operation by all connected stations C.) Loopback and collision detection disabled D.) Full-duplex NIC cards
You are logged into a router, what command would show you the IP addresses of routers connected to you? A. show cdp neighbors detail B. show run C. show neighbors D. show cdp
Which two protocol tools use ICMP? (Choose two) A. ping B. telnet C. configure D. traceroute E. show commands F. standard access lists
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
1) How a router established a neighbor relation ship in ospf
Which OSI Reference Layer controls end-to-end (host to host) communication? A.) Transport B.) Physical C.) Datalink D.) Network E.) Session
CCNA 
