Answer / guest

Answer: B

GNS stands for Get Nearest Server, initiated by a workstation.

Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End

1 Answers   Cisco, HCL,

---

which defined peer ip address an local subnet belong to crete? (Choose two)

0 Answers  

---

Identify 2 PPP characteristics? A.) Is proprietary to Cisco B.) Supports authentication C.) Support compression D.) Run on a multi-access network

3 Answers  

---

Which command will display adjacent routers found by the Cisco Discovery Protocol? A.) show all B.) show cdp entry C.) show ip neighbors D.) show cdp neighbor detail E.) show cdp neighbor F.) show neighbor

2 Answers  

---

How do you set the encapsulation type to PPP for an interface? A.) encap ppp B.) ppp encapsulation C.) encapsulation ppp D.) encapsulation ppp enable E.) ppp enable encapsulation

2 Answers  

---

Given the command 'cl?', what will it display? A.) Syntax of the 'clock' command B.) Syntax of the 'clear' command C.) All commands that begin with 'cl' D.) All commands that begin with 'c'

3 Answers  

---

Which statement about switched and routed data flows is correct? A. Switches create a single collision domain and a single broadcast domain. Routers provide separate collision domains B. Switches create separate collision domains but a single broadcast domain. Routers provide a separate broadcast domain C. Switches create a single collision domain and separate broadcast domains. Routers provide a separate broadcast domain as well D. Switches create separate collision domains and separate broadcast domains. Routers provide separate collision domains

1 Answers  

---

Which three are typical operational phases in a basic connection oriented neloyord service? (Choose three) A. call setup B. data transfer C. load balancing D. call termination E. call priortization F. data segmentation G. data link identification

1 Answers  

---

What is the function of the Application Layer in networking?

0 Answers  

---

Which OSI layer handles physical address, network topology? A.) Presentation B.) Physical C.) Transport D.) Application E.) Data-Link F.) Network

2 Answers  

---

What are two functions of the ICMP protocol? (Choose two) A. to map IP addresses to Ethernet addresses B. to map common names to network addresses C. to forward SNMP alerts to management consoles D. to generate an echo reply in response to a ping test E. to send a host or pod unreachable message from a router to the source of an undeliverable packet

1 Answers  

---

What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP

2 Answers  

---