What is difference between fast ethernet and ethernet port?

Answers were Sorted based on User's Feedback



What is difference between fast ethernet and ethernet port?..

Answer / minu manickam

Ethernet- 10BASE T,2,5(802.3) DATA can travel at speeed of
upto 10mbps upto distance of 100 m(T) to 500m(5).cat 3 utp

Fast Ethernet- 100basetx (802.3 u) data travel 10 times
faster at speed of upto 100mbps upto distance of 100 tp
412m.cat 5,6 utp

Giga Ethernet-1000baset(802.3 ab) data travels at 1000mbps
(1 gbps) upto distance of 100 m(cat 5 utp) to 10 kms
(fibers).

Is This Answer Correct ?    1 Yes 1 No

What is difference between fast ethernet and ethernet port?..

Answer / naima saleban

Difference between Fast Ethernet and Ethernet.
Ethernet IEEE 8.2.3 standard
•10 Mbps data rate
Minimum size packet 64bytes
Maximum size packet 1500bytes
Hub configuration
Fast Ethernet
Rational
Max drop length 100m
Standard with 10baseT4
Alternative 2pair 100baseTX cat 5(max 100m) and 100base FX optical fiber (max 2km)

Is This Answer Correct ?    0 Yes 0 No

What is difference between fast ethernet and ethernet port?..

Answer / raghu

Ethernet- 10BASE T,2,5(802.3) DATA can travel at speeed of
upto 10mbps upto distance of 100 m(T) to 500m(5).cat 3 utp

Fast Ethernet- 100basetx (802.3 u) data travel 10 times
faster at speed of upto 100mbps upto distance of 100 tp
412m.cat 5,6 utp

Is This Answer Correct ?    0 Yes 1 No

Post New Answer

More CCNA Interview Questions

What is the regional telco office called, where the customers local loop terminates? A.) Demarc B.) DTE C.) DCE D.) CO E.) CPE

1 Answers  


what is leased line and if any issue occur what will u do thai is trouble shootin occurs let leased line is down

1 Answers   Aptron, Cisco, HCL, Volvo,


3. What does a bridge use to segment a network? A. IP Addresses B. Broadcasts C. Application data D. Media Access Control addresses

2 Answers  


what hapeen we we configure default root on the router which is conected by isp supoese there are two router r1 is conected throug isp and and by s0 r1 is conexted to r2 if we apply degault root on r1 what will happen

3 Answers  


Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25

1 Answers  






Identify the definition of demarcation? A.) Date in which the WAN service contract expires B.) Cabling which extends from the WAN service provider to the customer C.) Division of responsibility, where the CPE ends and the local loop begins D.) Equipment which is located at the customer premises

1 Answers  


Which type of Ethernet framing is used for TCP/IP and AppleTalk? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP

1 Answers   Wipro,


Mention what is bootp?

0 Answers  


What is true about Link-State protocols? A.) They maintain a more complex table than distant vector protocols B.) They maintain a less complex table than distant vector protocols C.) They use routing ports D.) The maintain backup copies of the IOS

2 Answers  


Explain some overview of EIGRP?

2 Answers  


Suppose we are having two Switches i.e. Switch1 & Switch2 Port1 of Switch1 is Connected to Uplink and switch2 is also connected to switch1? So 1>Is there is any loop? 2>How we come to know that there is a loop created? 3>If we add Switch3 to switch2 then there is a possibility of loop Creation?

0 Answers  


Which Standard IP Access list commands will deny only the source address 1.1.1.1? A.) access-list 9 deny host 1.1.1.1 B.) access-list 9 deny 1.1.1.1 255.255.255.0 C.) access-list 9 deny 1.1.1.1 0.0.0.0 D.) access-list 9 deny 1.1.1.1 0.255.255.255 E.) access-list 9 deny 1.1.1.1 255.255.255.255

5 Answers  


Categories