Which layer defines bit synchronization? A.) Application B.) Network C.) Transport D.) Physical E.) Session F.) Session

1 Answers   Rooman,

---

What is the extended IPX access list range? A.) 901-1000 B.) 100-199 C.) 900-999 D.) 1000-1000

2 Answers  

---

Hi all of you, Actually this is interview qe? but i did,t do explain it completely so please give reply recently and completly Ans, what is sub-interface and inter-vlan ? And How to implement it on cisco router & switches and also which series router switches supported please write..........

2 Answers   Cisco,

---

Define routing?

0 Answers  

---

How to see the running-config & startup-config infor from global configuration mode. As we know, from priviledge mode we cn see it by executing command. i.e. Router#show running-config and Router#show startup-config Now wat is the coommands use in global configuration mode o see those info. Router(Config)# ??????

4 Answers   Juniper Networks,

---

Identify the prompt displayed if in privileged exec mode? A.) Router(config)# B.) Router# C.) Router> D.) Router(priv)#

2 Answers  

---

Which of the following statements is false? If your Frame Relay link does not support inverse ARP, you must manually map DLCIs to network Address. One of the major advantages of Frame Relay is its ability to connect to multiple PVCs using only one physical link. DLCI addresses are determined by the network administrator when installing the network. Which of the following statements is false? If your Frame Relay link does not support inverse ARP, you must manually map DLCIs to network Address. One of the major advantages of Frame Relay is its ability to connect to multiple PVCs using only one physical link. DLCI addresses are determined by the network administrator when installing the network. In order for two ends of virtual circuits to communicate using Frame Relay, their network addresses must be mapped to DLCIs.

2 Answers   Wipro,

---

What is the difference between the user mode and the privileged mode?

0 Answers  

---

The Network layer works with which of the following: A.) Globules B.) Bits C.) Packets D.) Segments E.) Frames

3 Answers  

---

Which of the following protocols are used to get an IP address from a known MAC address? A.) BootP B.) TCP C.) IP D.) ARP E.) RARP F.) ICMP

3 Answers  

---

Which command we give if router ios stucked?

0 Answers  

---

How many hop counts are by default and how much you can increase in eigrp protocol?

0 Answers  

---