Which two statements about the store and forward switching method are true? (Choose two) A. Latency remains constant regardless of frame size. B. Latency through the switch varies with frame length. C. The switch receives the complete frame before forwarding it. D. The switch checks the destination address as soon as it receives the header and begins forwarding the fram immediately.

1 Answers   CD,

---

Briefly explain the conversion steps in data encapsulation.

0 Answers  

---

What is the size of an ip address?

0 Answers  

---

Which of the following will apply IPX sap access list 1010 for incoming traffic, assume you are at the interface configuration? A.) ipx input-sap-filter 1010 in B.) ipx input-sap-filter 1010 C.) ipx access-group 1010 in D.) ipx access-list 1010 in

2 Answers  

---

what is the difference between 1 router and switch 2 router and hub 3 hub and switch 4 bridge and switch

1 Answers   Hathway,

---

What is the simplest way to remotely configure a router?

0 Answers  

---

Which of the following is true regarding standard ISDN BRI service? A.) ISDN BRI B channels are typically 64K. B.) ISDN BRI can handle only voice. C.) ISDN BRI can handle only data. D.) ISDN BRI has 2B and 1D channels. E.) ISDN BRI D channels are 16K. F.) ISDN BRI can handle voice and data.

2 Answers  

---

What is the default routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) Bandwidth and delay D.) Hop count

2 Answers  

---

On an ISDN BRI interface, the control channel is the 'D' channel. What is the rate of this channel? A.) 64 Kbps B.) 1.544 Mbps C.) 128 Kbps D.) 2.048 Mbps E.) 16 Kbps

4 Answers  

---

Which NetWare protocol works on layer 3--network layer--of the OSI model? A. IPX B. NCP C. SPX D. NetBIOS

1 Answers  

---

Which statement about Ethernet networks is true? A. The advantage of a full duplex is the ability to transmit data over 111 cable B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present C. Ethernet switches can use full duplex mode to connect multiple nodes to a single pod of a switch D. Half duplex is a cut through packet processing method that is vow fast little error correction Full duplex is a store and forward method that is slower but has better error correction

1 Answers  

---

What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP

2 Answers  

---