Identify the 3 methods routers learn paths to destinations? A.) Dynamic routing B.) None of the above, configured by default C.) Default routes D.) Administrative distance E.) Static routes

1 Answers  

---

Which of the following is an example of the Physical Layer? A.) TCP B.) ARP C.) IP D.) FDDI E.) LLC F.) Fast Ethernet

2 Answers  

---

Which three are typical operational phases in a basic connection oriented neloyord service? (Choose three) A. call setup B. data transfer C. load balancing D. call termination E. call priortization F. data segmentation G. data link identification

1 Answers  

---

hi friends i have some problem regarding technical round ahr round plz tell me what should the right answer technical questions 1 what is brouter 2 what is the menaing of 10 base2, 10 base 5 and 10baset 3 what is diffrence between bit rate and baud rate. and this question was tooooooooooo much difficult to me that hr said to me that rank me after the taking the all short of interview

5 Answers  

---

Which show command should you use to view Frame Relay Local Management Interface (LMI) Frame statistics? A. show lmi B. show ip route C. show interface D. show statistics E. show frame-relay lmi

1 Answers  

---

Identify the command to configure the router for IGRP autonomous system 100? A.) Router(config)# router igrp 100 B.) Router> router igrp 100 C.) Router# router igrp 100 D.) Router(config)# router igrp

3 Answers   CMS,

---

Which of the following is a characteristic of a switch, but not of a router? A.) Switches forward packets based on the IPX or IP address in the frame B.) Switches forward packets based on the IP address in the frame C.) Switches forward packets based on the MAC address in the frame D.) Switches forward packets based only on the IP address in the packet

1 Answers  

---

How many LMI types are available on Cisco routers? A.) Four B.) Two C.) Five D.) Three

3 Answers  

---

What does -1 mean in an extended IPX access-list? A.) Any IP address B.) Deny all C.) Deny host D.) Any host or any network

1 Answers  

---

Which port are used by Viruses? TCP or UDP?

8 Answers  

---

Identify the 2 commands the saves the running-config to NVRAM? A.) write memory B.) copy running-config startup-config C.) write network D.) write backup

2 Answers  

---

Which command displays the IPX SAP table? A.) show ipx sap B.) show sap C.) show ipx interface D.) show ipx servers E.) show ipx

1 Answers  

---