Identify the command that displays the SAP table? A.) show ipx servers B.)

Identify the command that displays the SAP table?

A.) show ipx servers

B.) display SAP table

C.) display SAP's

D.) show sap table

Question Posted / guest

1 Answers
4772 Views
I also Faced
E-Mail Answers

Identify the command that displays the SAP table? A.) show ipx servers B.) display SAP table ..

Answer / guest

Answer: A

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More CCNA Interview Questions

Identify the 2 commands that will display the status and information about interface E0 only? A.) show interface ethernet E0 B.) show interface E0 C.) show E0 D.) show int E0 E.) show interface

1 Answers

Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp

1 Answers

What is a characteristic of Store and Forward switches? A.) They work at wire speed. B.) They are the same as Cut-Through switching in 'prune' mode. C.) They forward based on transport layer info. D.) They forward the frame before it is completely read. E.) They increase latency.

1 Answers

Identify the command to configure ALL the default VTY ports? A.) Router(config)# line vty 0 4 B.) Router# line vty 0 4 C.) Router(config)# line vty D.) Router(config)# line vty 0

2 Answers Accel, CMS,

What is CRC and which layer it use?

4 Answers CMS,

What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.

3 Answers

In which layer switch is work?

16 Answers HCL, IINT,

what is the main features of link state routing protocols?

1 Answers Wipro,

Station A is transmitting data to station B, and expects an acknowledgment after every 400 bytes. After transmitting data for a while, the two stations determine the line is reliable and change to expecting and acknowledgement every 600 bytes. This is an example of (pick the best answer only): A.) BECN B.) Sliding Windows C.) Poison Reverse D.) Countdown timers E.) Split Horizon F.) Count to infinity

1 Answers

what is native vlan any one explain sooraj

7 Answers IBM,

What is the size of hello packets in eigrep protocol?

0 Answers

What command displays the OSPF section of the running-configuration?

1 Answers

For more CCNA Interview Questions Click Here