Answer / guest

Answer: C

Cisco has setup ranges of numbers to signify access lists.
900-999 is

the range for the Extended IPX access lists.

How network gateway is different from routers?

0 Answers  

---

Define network?

0 Answers  

---

Describe ICMP messages

4 Answers   HCL,

---

What command displays only OSPF routes?

2 Answers  

---

Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc

2 Answers  

---

Identify the 2 commands that display the clock rate configured on the serial0 interface? A.) show serial0 B.) show interface serial0 C.) show clock rate serial 0 D.) show controllers serial 0 E.) show running-config

5 Answers  

---

When setting up a frame-relay network between a Cisco router and a non-Cisco router, what encapsulation type should you use? A.) SAP B.) CISCO C.) IANA D.) Apollo E.) IETF F.) Q933A

2 Answers  

---

What was the key reason the International Organization for Standardization released the OSI model? A. users could access network servers faster B. different vendor networks could work with each other C. the industry could create a standard for how computers work D. network administrators could increase the overall speed of their network

1 Answers  

---

Which technologies listed below help prevent network loops in a switched (bridged) environment? A.) Store-and-Forward B.) IEEE 802.1d C.) Diikjstra Algorithm D.) Cut-Through E.) Spanning Tree Protocol F.) Routing

1 Answers  

---

Identify the hardware component used to store buffers, tables, running-configuration etc? A.) NVRAM B.) ROM C.) RAM D.) Flash

4 Answers  

---

What is 10base5 ethernet lans?

0 Answers  

---

Cisco routers use wildcard masking to identify how to check or ignore corresponding IP address bits. What does setting a wildcard mask bit to 0 cause the router to do? A. It tells the router to check the corresponding bit value. B. It tells the router to ignore the corresponding bit value. C. It tells the router to check its alternate routing list. D. It tells the router to use its primary routing list.

2 Answers  

---