How can u find reactive loads(Kvar)?





No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer





More Engineering Interview Questions

Why patra you join

0 Answers   Patra Corporation,


can DOL used with slip ring motor?

0 Answers   NTPC,


Question 97 - Two viruses a and b with masses of Ma and Mb are moving at velocities of Va and Vb respectively, facing towards each other and collide. After collision both masses of Ma and Mb disappear. (a) Find the total momentum available for both a and b. Hint : momentum = mass x velocity = M x V. (b) Guess the total energy E generated from the disappearance of a and b. Let c to be the velocity of light. Hint : E is equal to M c square.

1 Answers  


What is the full form of cable type-ayry

0 Answers   TATA,


what should be the recommended BDV of an oil transformer???

0 Answers  






difference between gauges and comparator

0 Answers  


what is the work of commutator and brush in motor

0 Answers  


How to calculate the angle in electrical transmission line

0 Answers  


Question 96 - In infrared spectrum, one of the factors affecting peak location is the mass of the atoms. The stretching frequency of a bond connected to a lighter atom will be greater than the same bond connected to a heavier atom. (a) For halogens like florine (F), chlorine (Cl), bromine (Br), iodine (I) and astatine (At), what is their IUPAC group number? Hint : The proton numbers for F, Cl, Br, I and At are 9, 17, 35, 53 and 85 respectively. (b) For the compounds of H-F, H-Cl, H-Br, H-I and H-At, which one has the lowest stretching frequency and which one has the highest stretching frequency? State the reasons.

1 Answers  


about metallurgy

0 Answers   Bhushan Power Steel,


What is the neutral voltage in practical AC systems

0 Answers   VCMS Technologies,


In an existing power plant (phase I) with step up transformers (3nos) with Ynd1 vector group to the 400KV bus bar,an extension power plant (phase II) with transformers (4nos) with Ynd11 vector group >. what are the consequences of such configuration ,please note that % impedance are also differ i.e. 15% & 10.5% the reason was that auxiliary supply interface is at different voltage levels i.e 400v & 6.6KV in phase i and phase II respectively .please advise ! Thank you !

1 Answers  





Categories