Answer / fasil

Constant power drive

In an existing power plant (phase I) with step up transformers (3nos) with Ynd1 vector group to the 400KV bus bar,an extension power plant (phase II) with transformers (4nos) with Ynd11 vector group >. what are the consequences of such configuration ,please note that % impedance are also differ i.e. 15% & 10.5% the reason was that auxiliary supply interface is at different voltage levels i.e 400v & 6.6KV in phase i and phase II respectively .please advise ! Thank you !

1 Answers  

---

Question asked in prototech first round

0 Answers   Protech,

---

when power factor leading above 1 than defect moter and kwh.

0 Answers   Syncom,

---

why we use transformers?

0 Answers  

---

Why patra you join

0 Answers   Patra Corporation,

---

Which LED light is better for fire safety? 24 V DC or 220 VAC? (In fireproof factory Godown)

0 Answers  

---

How can u find reactive loads(Kvar)?

0 Answers   econ,

---

Why we should not apply Ac supply to Cable when during the cable Hi pot test ?

0 Answers  

---

Methodology for calibration for ctm.... Explain in simple way pls

0 Answers  

---

What is the full form of cable type-ayry

0 Answers   TATA,

---

zeroth law of thermodynamics

0 Answers  

---

Question 95 - The following formula is used as a reference : (analyte signal) / (internal standard signal) = (f-factor) x (concentration of analyte) / (concentration of internal standard). A solution containing 3 mM of analyte and 4 mM of internal standard gave peak signals of 2 and 3 mamps respectively. Another similar solution containing 2 mM of analyte and 1 mM of internal standard gave peak signals of 1 and 4 mamps respectively. Find the average f-factor.

1 Answers  

---