What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router

1 Answers  

---

What does a Standard IP Access-list use as test criteria? A.) IP source address B.) IP source and destination address, protocol numbers and port numbers C.) IPX source and destination address D.) Source MAC address

2 Answers  

---

Which statement about switched and routed data flows is correct? A. Switches create a single collision domain and a single broadcast domain. Routers provide separate collision domains B. Switches create separate collision domains but a single broadcast domain. Routers provide a separate broadcast domain C. Switches create a single collision domain and separate broadcast domains. Routers provide a separate broadcast domain as well D. Switches create separate collision domains and separate broadcast domains. Routers provide separate collision domains

1 Answers  

---

What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC

1 Answers  

---

Can you give an overview of various components in IPSec?

0 Answers   CCIE,

---

which portecol is faster tcp udp spx

8 Answers  

---

Explain on which interface we always apply access-list?

0 Answers  

---

How to find Router Serial interface MAC address?

9 Answers   Wipro,

---

FastEthernet compares to 10baseT Ethernet in which of the following ways

1 Answers  

---

What should be the first command to create an access-list that prevents all users on subnetwork 10.10.128.0, using subnet mask 255.255.192.0, from being able to telnet anywhere? A.) access-list 101 deny tcp 10.10.128.0 0.0.63.255 any eq telnet B.) access-list 101 deny tcp 10.10.128.0 255.255.0.0 any eq telnet C.) access-list 101 deny tcp 10.10.128.0 255.255.192.0 any eq telnet D.) access-list 101 deny tcp 10.10.128.0 0.0.192.255 any eq telnet E.) access-list 101 deny tcp 10.10.128.0 0.0.128.255 any eq telnet F.) access-list 101 deny tcp 10.10.128.0 0.0.127.255 any eq telnet

1 Answers  

---

what is nat.types of nat

3 Answers  

---

When you issue the command show version your router returns "Configuration register is 0x0101" From where does the router boot? A. ROM B. NVRAM C. Flash D. a TFTP server

3 Answers  

---