1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

Where is the backup configuration file stored?

A.) RAM

B.) ROM

C.) Console

D.) NVRAM

Question Posted / guest

Answers were Sorted based on User's Feedback



Where is the backup configuration file stored? A.) RAM B.) ROM C.) Console D.) NVRAM..

Answer / guest

Answer: D

One location to store the backup configuration is NVRAM.

Is This Answer Correct ?    23 Yes 1 No

Where is the backup configuration file stored? A.) RAM B.) ROM C.) Console D.) NVRAM..

Answer / and

c

Is This Answer Correct ?    6 Yes 3 No

Post New Answer

More CCNA Interview Questions

What is quality of ipv6?

1 Answers  

Which of the following protocols are used for logical network addressing? A.) IP B.) TCP C.) ARP D.) ICMP E.) RARP F.) BootP

1 Answers  

what is diffrence betwwen mpls and frame really

1 Answers   Aptron, Volvo,

When you issue the command show version your router returns "Configuration register is 0x0101" From where does the router boot? A. ROM B. NVRAM C. Flash D. a TFTP server

3 Answers  

What is the syntax to use to configure the port on a Catalyst 5000 switch? A.) slot port/type B.) type slot/port C.) port slot/type D.) port type/slot

2 Answers  

Which two commands allow you to verify address configuration in your unternetword? (Choose two) A. ping B. trace C. verify D. test ip E. Echo ip F. config ip

2 Answers  

What would be the proper wildcard mask to permit all odd numbered hosts on the 10.48.0.0/12 network? access-list 1 permit 10.48.0.0 0.15.255.255 access-list 1 permit 10.48.0.1 0.15.255.254 access-list 1 permit 10.48.0.0 0.15.255.1 access-list 1 permit 10.48.0.0 0.0.0.254 access-list 1 permit 10.48.0.0 0.0.0.255

5 Answers  

When we use interface mode?

1 Answers  

What is true when creating static route? A.) The mask parameter is optional B.) The administrative distance is required C.) The gateway parameter is required D.) The administrative distance is optional

1 Answers  

Which command, that is used to test address configuration, uses Time-To-Live (TTL) values to generate messages from each router. A) telnet B) ping C) trace D) bootp

4 Answers  

Which command, that is used to test address configuration, uses Time-To-Live (TTL) values to generate messages from each router. A. trace B. ping C. telnet D. bootp

1 Answers  

Define the virtual channel?

1 Answers  

For more CCNA Interview Questions Click Here
Categories