tell me our traditional ip routing is what
A--conectless
b----conection orented
c-----pacekt switching
d------ckt switching
slect any two
this is the question which i forgot to incoprate
next-questions
Answers were Sorted based on User's Feedback
Answer / jaccckle
answer is
b----conection orented
&
d------ckt switching
as we use TCP protocol which is connection oriented.
and our traditional ip routing happen with ckt switching.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / harish kumar
b----conection orented
d------ckt switching
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / shahin
the correct answer is -
A-Connectionless
C-Packet Switching.
hey i m 70% sure abt the correctness of this answer. Cn
anyone explain plzzz...
Is This Answer Correct ? | 1 Yes | 2 No |
What is link aggregration?? How many types of protocol are used on that???
How many subnets can be gained by subnetting 172.17.32.0/23 into a /27 mask, and how many usable host addresses will there be per subnet?
A routing table contains static, RIP, and EIGRP routes for the same destination network. Which route would normally be used to forward data?
What is the cladding?
Which ISDN protocol prefix specifies switching and signalling? A.) I B.) E C.) Q D.) S
Put the following steps of encapsulation into the correct order: 1) The data is broken into segments to be organized 2) Frames are converted to 1s and 0s to be put on the wire 3) Packets are converted into frames 4) Information that users enter is converted into data 5) The segments are changed to packets to be routed A.) 4, 1, 3, 2, 5 B.) 4, 5, 1, 3, 2 C.) 2, 3, 1, 4, 5 D.) 4, 1, 5, 3, 2
hello sir , if i finish this certification is the job is conform ?? and in chennai were i can do this ??
Identify the correct pair of Novell Ethernet encapsulation and Cisco terminology? A.) Ethernet II, Snap B.) Ethernet 802.3, Novell-Ether C.) Ethernet SNAP, Arpa D.) Ethernet 802.2, Snap
Why subnetting is used?
What is DLCI?
What is the syntax to use to configure the port on a Catalyst 5000 switch? A.) slot port/type B.) type slot/port C.) port slot/type D.) port type/slot
Hi, If we create more Gateway from one our Router Interface Gateway (Example: by set up a ISA server etc) will it effect on our bandwidth to be low? please help me