Answer / guest

Answer: B

Suppose we are having two Switches i.e. Switch1 & Switch2 Port1 of Switch1 is Connected to Uplink and switch2 is also connected to switch1? So 1>Is there is any loop? 2>How we come to know that there is a loop created? 3>If we add Switch3 to switch2 then there is a possibility of loop Creation?

0 Answers  

---

Which of the following can reply to a Novell Get Nearest Server (GNS) request? A.) Local Novell server B.) Remote Novell Printer C.) Cisco router D.) Novell client

1 Answers  

---

How many fillers we can put in one ip of ipv6?

0 Answers  

---

ip dhcp excluded-address 192.168.0.1 192.168.0.19 what is the use of that command can any one explain it

9 Answers  

---

What is the maximum hop count for Link-State protocols? A.) 15 B.) there is no hop count limit C.) 256 D.) 16

2 Answers  

---

What is the UDP datagram format? A. Source Port - 16 bits, Destination Port - 16 bits, Length - 16 Bits, Checksum - 16 bits, Data B. Destination Port - 16 bits, Source Port - 16 bits, Length - 16 Bits, Checksum - 16 bits, Data C. Source Port - 16 bits, Destination Port - 16 bits, Checksum - 16 Bits, Length - 16 bits, Data D. Source Port - 8 bits, Destination Port - 8 bits, Length -8 Bits, Checksum - 8 bits, Data

1 Answers  

---

let threr are three router 1 is cionected to two and two is conected to three that is 1----2----3 now we can ping 2 from 3 and 1 to two but we are not able to ping 1 to 3 let router 1 is local and rest of two are remote what should be urs troubleshoot steps

2 Answers   Volvo,

---

What are four functions/characteristics of the network layer of the OSI model? (Choose four) A. It uses a two-part address B. It maintains routing tables C. It uses broadcast addresses D. It establishes network addresses E. It provides access to the LAN media F. It provides media independence for upper layers G. It provides path selection for Internetwork communication

1 Answers  

---

For IPX, what is the DEFAULT Cisco Encapsulation on an Ethernet interface? A.) novell-ether B.) gns C.) snap D.) arpa E.) sap F.) dix

1 Answers  

---

Identify the command to configure the router to boot from an IOS located on a TFTP server? A.) boot system tftp IOS.exe 172.16.5.1 B.) boot system tftp 172.16.5.1 IOS.exe C.) boot system flash tftp 172.16.5.1 D.) boot system IOS.exe 172.16.5.1

1 Answers  

---

Which protocol called rapid protocol?

0 Answers  

---

Identify the correct IGRP configuration? A.) Router# router igrp 100 Router# network 10.0.0.0 B.) Router(config)# router igrp 100 Router(config-router)# network 10.0.0.0 C.) Router(config)# router igrp Router(config-router)# network 10.0.0.0

1 Answers  

---