Answer / ritesh

65535

The CSMA/CD Ethernet IEEE committee is defined as which of the following? A.) 802.2 B.) 802.3 C.) 802.4 D.) 802.5

2 Answers  

---

Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End

1 Answers   Cisco, HCL,

---

What command can you type to view the connections after telneting into multiple routers simultaneously? A.) sh users B.) sh ports C.) sh host D.) sh sessions

1 Answers  

---

What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN

1 Answers  

---

Which of the following statements are true? A.) Store and forward switching creates variable latency through the switch B.) Cut through switching creates variables latency through the switch C.) Cut through switching works at wire speed D.) Store and forward switching works at wire speed

1 Answers  

---

What is the passive topology in ccna?

0 Answers  

---

What is true about Link-State protocols? A.) They maintain a more complex table than distant vector protocols B.) They maintain a less complex table than distant vector protocols C.) They use routing ports D.) The maintain backup copies of the IOS

2 Answers  

---

What is Data, management, native, default,trunk and access vlan?

1 Answers  

---

In transport layer, for connection oriented communication Three way handshake process is there to establish a connection. So question is that, when a host send an ACK messages to another host with host intend to establish a connection, the source host send it as Broadcast or unicast message? Cud anyone explain this. Thanks in advance.

3 Answers   HCL,

---

3 router configured with RIP & Ripv2 rotuer 1- connected with router 2 having sr ip 10.0.1.2 routing : ripv2 router 2: connected with router 1 and router 3 having sr 0 ip 10.0.1.3 & sr 1 ip 11.0.1.2 routing :rip & ripv2 router 3: connected with router 2 having sr ip 11.0.1.3 routing: rip is there communication possible btween these networks ? if yes how

2 Answers  

---

can we measure how much a host exact bandwidth using by a network cable which is communicating over the network? options: 1- via Router 2- Switch, 3- other device... if yes.. then how ( with every option)

3 Answers  

---

Which 2 commands shows the Cisco IOS filename? A.) show IOS B.) show ver C.) show flash D.) show mem E.) show NVRAM

1 Answers  

---