What are two characteristics of the RARP protocol? (Choose two) A. it generates parameter problem messages B. it maps IP addresses to Ethernet addresses C. it maps Ethernet addresses to IP addresses D. it is implemented directly on top of the data link layer

1 Answers  

---

Identify the purpose of the wildcard mask? A.) Match a certain portion of the IP address while ignoring the rest of the address B.) Determine the class of the IP address C.) Determine the network portion of an IP address D.) Hide the host portion of an IP address

1 Answers  

---

What type of Ethernet operation allows only one entity to transmit at a time? For example, if someone else is transmitting, they must wait. A.) Full-Duplex B.) Dual-Duplex C.) Half-Duplex D.) Latex E.) Quarter-Duplex F.) Suplex

1 Answers  

---

How ICMP is used in ping and traceroute facilities

3 Answers  

---

All equipment located at the customers site is called: A.) CPE B.) CO C.) DCE D.) Demarc E.) DTE

1 Answers  

---

What is the best Difference between RIP, OSPF, EIGRP

7 Answers   Airtel, Gemini, HP,

---

Identify the switching method that receives the entire frame then dispatches it? A.) Cut-through B.) Receive and forward C.) Store and forward D.) Fast forward

1 Answers  

---

Novell IPX network addresses have two conferrable parts. The network administrator specifies the IPX network number. How is the node number determined? A. It is the serial number of the given device B. It is assigned as a lease by Novell DHCP C. It is also set by the network administrator D. It is usually the MAC address of one Interface E. It is downloaded by Netware Core Protocol (NCP)

1 Answers  

---

I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

5 Answers  

---

What is the logical link control?

0 Answers  

---

What is the difference between simple authentication and md5?

0 Answers  

---

Identify 3 IP routing protocols? A.) RIP B.) AURP C.) OSPF D.) IGRP E.) ARP F.) ICMP

3 Answers  

---