Which layer of the 7 layer model is responsible for representing the application information between 2 different OS's? For example, converting ASCII to EBCIDIC. A.) Transport B.) Application C.) Physical D.) Session E.) Presentation F.) Network

2 Answers  

---

intial information of packey occur on which layer application sessions physical mine answer physical

1 Answers  

---

How do you configure a Cisco router to route IPX?

0 Answers  

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

1 Answers  

---

What is HSRP and what is difference between HSRP and GLBP

2 Answers   Infosys,

---

Which ISDN specification series deals with Concepts and Terminology? A.) C- Series B.) I- Series C.) Q-Series D.) 911-Series E.) J-Series F.) F-Series

1 Answers  

---

Which statement about half duplex Ethernet operations is true? A. With half duplex transmission frames feed into a single cable in one direction at a time. B. Half duplex transmission between stations is achieved by using point to point Ethernet and Fast Ethernet connections C. Half duplex transmission between stations is achieved by using point to munificent Ethernet and Fast Ethernet connections D. Half duplex Ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end of the connection

5 Answers  

---

Why do we have a Layered Model? 1) It reduces complexity 2) Allows for a standardized interface 3) Facilitates modular engineering 4) Ensures interoperable technology 5) Accelerates evolution 6) Simplifies teaching and learning

1 Answers  

---

The Cisco Discovery Protocol (CDP) periodically sends out a multicast packet (at layer 2). Which command will alter the default interval of 60 seconds? A.) cdp hold 111 B.) cdp wait 111 C.) cdp interval 111 D.) cdp 111 E.) cdp timer 111

1 Answers  

---

what is LAPB

2 Answers   ASD Lab,

---

What does the 'S' mean when looking at the routing table? A.) Statically connected B.) Directly connected C.) Dynamically attached D.) Shutdown route

1 Answers  

---

Which statement about the flow control function of TCP is true? A. TCP makes no snarl to check for lost or duplicate data packets B. The application layer must sequence data packets when using TCP C. TCP controls the flow of UDP data through negative acknowledgements (NAK) D. TCP is a connection-oriented protocol that acknowledges receipt of data packets and is considered reliable

1 Answers  

---