Answer / guest

Answer: B

Access lists are numbered. Which of the following ranges could be used for an IP access list? A. 600 - 699 B. 100 - 199 C. 1 - 99 D. 800 - 899 E. 1000 - 1099

1 Answers  

---

Given the following IP address from the Class C address range 192.168.21.12. Your network plan needs addresses for 28 small prkps Each office uses its own shored. The network design specifies that you confound for five bits of subnetting. When you confound for this in Cisco IOS software which shored mask should you use? A. 255.255.0.28 B. 255.255.255.0 C. 255.255.255.28 D. 255.255.255.248 E. 255.255.255.252

1 Answers  

---

Which statement about switched and routed data flows is correct? A. Switches create a single collision domain and a single broadcast domain. Routers provide separate collision domains B. Switches create separate collision domains but a single broadcast domain. Routers provide a separate broadcast domain C. Switches create a single collision domain and separate broadcast domains. Routers provide a separate broadcast domain as well D. Switches create separate collision domains and separate broadcast domains. Routers provide separate collision domains

1 Answers  

---

What does the 'S' mean when looking at the routing table? A.) Statically connected B.) Directly connected C.) Dynamically attached D.) Shutdown route

1 Answers  

---

what is ACLs? what is the reasons to create ACLs?

1 Answers  

---

Explain why ip address called logical address?

0 Answers  

---

When editing a line in the CLI mode, what does 'CTRL-A' do? A.) Moves you to the previous command. B.) Moves you to the next word. C.) Moves you to the end of the line. D.) Moves you to the next command. E.) Moves you to the beginning of the line.

1 Answers  

---

What is the default bandwidth size of t1 routers?

0 Answers  

---

Define routing?

0 Answers  

---

Identify 3 methods used to prevent routing loops? A.) Split horizon B.) Holddown timers C.) Poison reverse D.) SPF algorithm E.) LSP's

2 Answers  

---

Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp

2 Answers  

---

What three occurrences will reset the holddown timer after a triggered update? A.) Infinity is finally defined as some max number B.) HD Timer expires C.) Another update is received indicating a better metric D.) The router receives a processing task proportional to the number of links in the internetwork E.) The router detects fault LSP's propagating through the internetwork F.) Another update is received indicating net status changed

1 Answers  

---