You need to come up with a TCP/IP addressing scheme for your

company. How

many network IDs must you allow for when you define the
subnet mask for

the network?

A.) One for each WAN link

B.) One for each router interface

C.) One for each NIC installed in each client

D.) One for each subnet with hosts

E.) One for each host ID



You need to come up with a TCP/IP addressing scheme for your company. How many network IDs mus..

Answer / guest

Answer: A D

Is This Answer Correct ?    9 Yes 0 No

Post New Answer

More CCNA Interview Questions

Which two statements about IP RIP are true? (Choose two) A. It limits hop counts to 31 B. It is a link state routing protocol C. It uses autonomous system numbers D. It is capable of load sharing over multiple paths E. It uses bandwidth as the metric for path selection F. It broadcasts updates every 30 seconds by default

1 Answers  


What is half duplex and full duplex?

0 Answers  


ok this is practical senario question how can we comunicate two diffrent network host by i single 1603 sires of cisco router rember that the cisco series of that router have singe 100mbps ethernet now think think write all command answer is so simple i wiil; give the answer after 20 visit til then wait

2 Answers  


What key do you use to view the last command? A.) Left Arrow B.) Space Bar C.) Up Arrow D.) Right Arrow

2 Answers  


We have one router,we r using two routing protocol eigrp 90 net 1.1.1.0/16, ospf 110 net 1.1.1.0/24 on same router, Is it possible?

6 Answers   Wipro,






Which ISDN specification series deals with Concepts and Terminology? A.) C- Series B.) I- Series C.) Q-Series D.) 911-Series E.) J-Series F.) F-Series

1 Answers  


Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

1 Answers  


If there is only 2 host in bus topology is that possible collision accord?

0 Answers  


Which router command allows you to view the entire contents of all access lists? A. Router# show interface B. Router> show ip interface C. Router# show access-list D. Router> show all access-list

3 Answers   jetking,


Which of the following is an example of a Transport Layer protocol? Ethernet IP TCP RS-232

2 Answers  


what is standard and extended acess list? what are the commands for extended and acess list?

3 Answers   HCL,


what is distance vector protocol link state protocol and what is the diffrence between them

5 Answers   Wipro,


Categories