Which command displays the IP addresses assigned to specific host names? A.

Which command displays the IP addresses assigned to specific
host names?

A. show hosts

B. show interface

C. ping host name

D. config host name

E. show host mapping

F. show host ip address

G. trace ip addresses host name

H. a partridge in a pear tree

Question Posted / guest

2 Answers
5208 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Which command displays the IP addresses assigned to specific host names? A. show hosts B. sho..

Answer / vikram pratap singh

F-Show host ip address

Is This Answer Correct ?

0 Yes

0 No

Which command displays the IP addresses assigned to specific host names? A. show hosts B. sho..

Answer / guest

Answer: A

Is This Answer Correct ?

1 Yes

2 No

Post New Answer

More CCNA Interview Questions

When would you use ISDN? A.) To connect LANs using POTS B.) To support applications requiring voice, data, and video C.) When you need a consistent and very high rate of data speed D.) To connect to IBM mainframes

1 Answers

You want to clear the outputs on your serial interface showing errors on the interface. Which command do you type?

1 Answers

What is the meaning of synchronization?

0 Answers

thnx Jitender singh...as u told to install a stp in switches and problem vil b get solved...i wanna kno how to install stp in switches?? plz tel me detailled steps... thanx for ur answer.

1 Answers

what is the difference between eigrp and ospf

6 Answers IBM, Wipro,

How do you configure a Cisco router to route IPX?

0 Answers

On Cisco catalyst 5000 how would you set the second port on the controller in the first slot to full duplex? A.) Set port duplex 1/1 full B.) Set port duplex 1/2 full C.) Set port duplex 0/1 full D.) Set port duplex 0/2 full

2 Answers

The following is partial output from a routing table ; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' Which routing protocol is being used? (assuming defaults have not been changed) A.) OSPF B.) RIP C.) BGP D.) IGRP

1 Answers

What is network?

0 Answers

HI I am Rajveersinh. I am Leaving in Ahmedabad-gujarat. I am Hardware & Networking Stundent In JETKING. my Intersted in CICKO Side. Please send ME totel detail in CICKO surtifiction my E-mail ID IS as_raj@ymail.com

6 Answers HCL,

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 B.) Router(config)# interface serial1/0 C.) Router(config)# interface serial0.1 D.) Router(config)# interface serial0/1

4 Answers

Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers

For more CCNA Interview Questions Click Here