Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following is true?
A. The default is to send debug output to the console screen.
B. To view debug output from a telnet session, the "terminal
monitor" command must be used
C. If the "logging buffered" command is used, the debug
output would be sent to RAM and can be viewed with the "show
log" command
D. If the "no console loggin" command were configured,
output would besent to a telnet session
E. All of the above
F. None of the above
G. A, B, and C.
H. A, C, D, and E.
- 2 Answers
- 4679 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Why ESP Transport mode is not compatible with NAT????? Though New IP Header in Tunnel mode & Original IP Header in Transport mode are out of Authentication & Encryption.
How can you assign a vlan to a switch port?
How network gateway is different from routers?
What is the difference between unicast, multicast, broadcast, and anycast?
What is the mac address?
Which IEEE standard is used to define Wi-Fi? A. IEEE 802.3 B. IEEE 802.5 C. IEEE 802.11h D. IEEE 802.11c E. IEEE 802.11
HI ALL! RECENTLY I COMPLETED MY MCITP, CCNA COURSE, I AM PLANNING TO DO CCNA CERTIFICATION, ANYBODY PLZ SUGGEST ME HOW MUCH TIME (MONTHS) REQUIRED TO PREPARE FOR CCNA, BOOKS, JOB SCOPE IN INDIA, QUALIFICATION REQUIRED, ANY JOB FOR FRESHERS? YOUR GOOD ADVISE IS HIGHLY APPRECIATED. Reg.Khaleel
Can you define in short what VPN is?
Based on the DR AND BDR discussion i want to put one question the question is what is the name of protocol which is responsible;e for DR and BDR selection
What is the maximum hop count for Link-State protocols? A.) 15 B.) there is no hop count limit C.) 256 D.) 16
Which cable we connect in db-9?
What ISDN protocol specifies concepts, terminology, and services? A.) Q B.) S C.) I D.) E
CCNA 
