Identify the default values that make up IGRP's composite
metric?

A.) Bandwidth

B.) Load

C.) Reliability

D.) MTU

E.) Delay



Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load..

Answer / guest

Answer: A E

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More CCNA Interview Questions

Identify 2 features of PPP CHAP authentication? A.) Username and password is sent in clear text B.) Authentication messages are sent periodically during the connection C.) Less secure then PAP D.) Local router 'challenges' the remote router

1 Answers  


How we ping ICMP a NIC with a correct IP address but with wrong MAC address Do all NIC's can run inpromiscuous mode

3 Answers   Cisco, HCL,


What is the difference between dynamic ip and static ip addressing?

1 Answers  


Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash tftp D. copy tftp flash

2 Answers  


what is frame relay.and how it is different from isdn

1 Answers   HCL,


Which layer defines bit synchronization? A.) Application B.) Network C.) Transport D.) Physical E.) Session F.) Session

2 Answers  


what is prefix list

1 Answers   Infosys,


What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services

1 Answers  


Which command will display the IPX routing table? A.) show routes B.) show routes ipx C.) show routes protocol=ipx D.) show ipx E.) show ipx route

1 Answers  


A traffic light is an example of what type of mechanism? A.) Collision detection B.) Flow control C.) Sequence numbering D.) Network management

1 Answers  


In port based access-list which command you give instead of ip?

1 Answers  


UDP works at which layer of the DOD model? A.) Internet B.) Host-to-Host C.) Transport D.) Data Link

1 Answers  


Categories