Which command will display the IPX routing table?

A.) show routes

B.) show routes ipx

C.) show routes protocol=ipx

D.) show ipx

E.) show ipx route



Which command will display the IPX routing table? A.) show routes B.) show routes ipx C.) s..

Answer / guest

Answer: E

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More CCNA Interview Questions

what is leased line and if any issue occur what will u do thai is trouble shootin occurs let leased line is down

1 Answers   Aptron, Cisco, HCL, Volvo,


What is an advantage of LAN segmentation? A.) Increases broadcasts. B.) Increases collisions. C.) Provides more protocol support. D.) Decreases broadcasts. E.) Routing protocol support.

2 Answers   Wipro,


What type of switching creates variable latency through the switch? A.) Cut-Through B.) Inverted C.) Layer 4 D.) Multiplexed E.) Store and Forward

1 Answers  


Define ios?

1 Answers  


Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network

3 Answers  


Which two statements about IP RIP are true? (Choose two) A. It limits hop counts to 31 B. It is a link state routing protocol C. It uses autonomous system numbers D. It is capable of load sharing over multiple paths E. It uses bandwidth as the metric for path selection F. It broadcasts updates every 30 seconds by default

1 Answers  


What is point-to-point protocol in ccna?

1 Answers  


After how long ospf exchange its topology table?

1 Answers  


With one method for transmitting frames through a switch, the switch receives the complete frame and checks the frame CRC before forwarding the frame. What is the switch transmission method called? A. CSMA/CD B. Full Duplex C. Cut-Through D. Half-Duplex E. Fragmentation F. Store and Forward

2 Answers  


Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc

1 Answers  


Which statement is true regarding the user exec and privileged exec mode? A.) The '?' only works in Privileged exec B.) They are identical C.) They both require the enable password D.) User exec is a subset of the privileged exec

1 Answers  


Is hub intelligent device?

1 Answers  


Categories