Answer / guest

Answer: B

The Network Layer routes data from one node to another,
sends data from

the source network to the destination network. The router
will use

packet switching to move a packet from one interface or
port, to another

through the network cloud.

What 3 sources can configuration commands be placed into RAM? A.) HP Openview B.) Console C.) Vterminal D.) TFTP server E.) NVRAM

1 Answers  

---

Identify the purpose of ICMP? A.) Avoiding routing loops B.) Send error and control messages C.) Transporting routing updates D.) Collision detection

2 Answers   Hughes,

---

Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport

1 Answers  

---

How do you disable advanced editing? A.) terminal editing B.) terminal no editing C.) disable editing D.) no terminal editing

2 Answers  

---

Eight stations connected to separate 10 Mobs pods on a Layer 2 switch will give each station how many Mobs of bandwidth? A. 1.25 B. 4 C. 16 D. 10 E. 80

1 Answers  

---

Can you explain PAP?

0 Answers   CCIE,

---

How do you find valid hosts in a subnet?

0 Answers  

---

When a router knows the IP address, but does not know the MAC address of the device it wishes to contact, it uses the ARP (Address resolution protocol) to determine the MAC address. After it learns the MAC address, it stores this information in the ARP cache. What is the command to view the ARP cache? A.) sh mac B.) show cache C.) show arp D.) sh arp interfaces E.) show ip cache

2 Answers  

---

what is firewall how fiarewall work how many interfaeces in the cisco pix 501 firewall what is the working of that dmz interface

3 Answers   Aptron, Volvo,

---

What does 'P' mean when running a Trace? A.) Good route B.) Protocol unreachable C.) Source Quench D.) Destination unreachable

2 Answers  

---

Which of the following are Transport layer protocols? A.) UDP B.) TCP C.) NBP D.) IP E.) SPX

4 Answers   TCP,

---

A company running RIP V1 protocol on their 2 seperate networks, each nw has 14 routers, if the two nw wants to be merged with each other total no of routers will be 28. but rip metric is hop count(15). What needs to be done if this setup needs to be work ?

2 Answers   Satyam,

---