Answer / guest

Answer: B

The TCP/IP Transport Layer (OSI) and Host to Host (DOD)
protocols use

TCP and UDP.

Which command will copy the routers configuration from NVRAM to a Network file server? A.) copy start tftp B.) copy start tftp server C.) copy tftp startup-config D.) copy running-config tftp E.) copy startup-config tftp

1 Answers  

---

What is a key use of a device hardware address? A. to obtain a vendor code / serial number from the user B. to transmit a frame from one Interface to another Interface C. to transmit a packet from one local device to another local device D. to transmit data from one local device to a remote device across the internet E. to contain logical information about the device to use for end-to-end transmission

1 Answers  

---

Why would you use static routing instead of dynamic routing? A.) When you want automatic updates of the routing tables B.) All the time C.) When you have very few routes and want to conserve bandwidth D.) When you have a gateway of last resort

1 Answers  

---

what is the network address?

2 Answers   HCL,

---

The Datalink layer works with which of the following: A.) Packets B.) Bits C.) Globules D.) Frames E.) Segments

2 Answers  

---

How many parts of ping?

0 Answers  

---

Which command would you type to show SAP and RIP updates you are receiving on an interface? A.) sh ipx servers B.) sh ipx traffic C.) sh ipx interface D.) sh ipx route

2 Answers  

---

How broadcast is created in switch

1 Answers  

---

Can you explain how L2F data tunneling process works?

1 Answers   CCIE,

---

Differentiate full-duplex from half-duplex.

0 Answers  

---

Which two commands allow you to verify address configuration in your unternetword? (Choose two) A. ping B. trace C. verify D. test ip E. Echo ip F. config ip

2 Answers  

---

Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay

1 Answers  

---