Which command loads a new version of the Cisco IOS into a
router?

A. copy flash ftp

B. copy ftp flash

C. copy flash tftp

D. copy tftp flash

Answers were Sorted based on User's Feedback



Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy f..

Answer / guest

Answer: D

Is This Answer Correct ?    18 Yes 0 No

Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy f..

Answer / aaa

copy tftp flsh

Is This Answer Correct ?    6 Yes 1 No

Post New Answer

More CCNA Interview Questions

How do you find valid hosts in a subnet?

0 Answers  


Which commands will restart the router? A.) router#system exit B.) router >reload C.) router#shutdown D.) router#reload E.) router#(config)reload F.) router#system restart

10 Answers  


CO is an acronym for which of the following? A.) Central Office B.) Capital Office C.) Central Operator D.) Company Office

1 Answers  


if i am using active directory,i have router also.then how i configure router,means which address will be default gatway in active directory & roter how to give ip address details in router.

1 Answers   IBM,


How many fillers we can put in one ip of ipv6?

0 Answers  






IP extended access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) all of the above C.) protocol D.) source address E.) port

1 Answers  


When a Distance Vector routing protocol detects that a connected network has gone down, it sends out a special routing update packet, telling all directly connected routers that the distance to the dead network is infinity. This is an example of which routing technology? A.) ICMP. B.) Only Link State routing protocols have this intelligence. C.) Triggered updates. D.) Garrison-4. E.) Split Horizon. F.) Poison Reverse.

1 Answers  


Based on the DR AND BDR discussion i want to put one question the question is what is the name of protocol which is responsible;e for DR and BDR selection

7 Answers   Patni,


What is an administrative distance of 0 mean? A.) 0 means unbelievable B.) 0 is for EIGRP C.) 0 is the default distance for directly connected networks D.) 0 means unreachable

2 Answers  


Which of the following is a layer 2 device? A.) Switch B.) Bridge C.) Repeater D.) Hub

2 Answers  


router

4 Answers   Infotech,


Explain what are partial updates?

0 Answers  


Categories