Answer / vikesh

type slot/port (B)

What is the default bandwidth of a serial connection? A.) 1200 baud B.) 1.544 Mbps (T1) C.) 10 Mbps D.) 96Kpbs

2 Answers  

---

Which command will display adjacent routers found by the Cisco Discovery Protocol? A.) show all B.) show cdp entry C.) show ip neighbors D.) show cdp neighbor detail E.) show cdp neighbor F.) show neighbor

2 Answers  

---

Identify the 3 Internet layer IP protocols? A.) NetBios B.) IPX C.) ARP D.) IP E.) RARP

1 Answers  

---

Explain the difference between baseband and broadband transmission in ccna?

0 Answers  

---

There are two processes to pair MAC address with IP addresses. Which process finds an IP address from a MAC address? A. RARP B. ARP C. RIP D. IGRP

3 Answers  

---

Identify the correct pair of Novell Ethernet encapsulation and Cisco terminology? A.) Ethernet II, Snap B.) Ethernet 802.3, Novell-Ether C.) Ethernet SNAP, Arpa D.) Ethernet 802.2, Snap

1 Answers  

---

Identify the command that saves the configuration stored in RAM to NVRAM? A.) copy running-config startup-config B.) copy tftp running-config C.) copy startup running D.) copy active to backup

2 Answers  

---

hi friend i am stuck in the big problem.this problem is regading pix firewall. i have a cisco pix 515e firewall inmy company.now when i configure it and after rebooting it the ACT link never getup.when i apply clear config all comand the ACT link get up after oveservation i see that there is fauilover problem when i apply failover active ACT link agin get up is there any way to get my firewall in standby mode rember that there is only on firewall within my n/w i am lookig towards all of you jitendera kumar sinha

0 Answers  

---

What is Transport and Tunnel mode?

0 Answers   CCIE,

---

Can you explain what IPSec is

2 Answers   CCIE,

---

Which of the following are examples of the Session Layer? A.) TCP B.) RPC C.) SQL D.) NFS E.) Token Ring

1 Answers  

---

What is the default switching method for the Cisco 5000 series? A.) Cut-through B.) Store-and-splice C.) Latency D.) Store-and-forward

1 Answers  

---