Which is true regarding half duplex Ethernet operation?

A.) Half Duplex ethernet technology provides a transmit
circuit connection

wired directly to the receiver circuit at the other end

B.) Half duplex transmission between stations is achieved by
using point

to multipoint Ethernet and Fast Ethernet

C.) With Half Duplex transmission logically circuits feed
into a single

cable creating a situation similar to a one way bridge

D.) Half Duplex transmission between stations is achieved
using Point to

Point Ethernet & Fast Ethernet

Answers were Sorted based on User's Feedback



Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provi..

Answer / guest

Answer: C

Is This Answer Correct ?    3 Yes 0 No

Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provi..

Answer / laksamba indra bahadur

C.) With Half Duplex transmission logically circuits feed
into a single

cable creating a situation similar to a one way bridge

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More CCNA Interview Questions

On which mode we give debug command?

0 Answers  


You need to come up with a TCP/IP addressing scheme for your company. Which two factors must you consider when you define the subnet mask for the network? A.) The location of DHCP servers B.) The volume of traffic on each subnet C.) The number of subnets on the network D.) The location of the default gateway E.) The number of host IDs on each subnet

2 Answers  


from last ten days i watched that no any new questions are placed in ccna catogarey.so plz place the questions it is very use full to beginers like us

2 Answers   HCL,


What is the difference between tracert and traceroute?

0 Answers  


What is Transport and Tunnel mode?

0 Answers   CCIE,






Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) Booter load D.) RAM E.) Flash

2 Answers  


What is difference between IPv4 & IPv6??

7 Answers   Hathway,


What’s the default CDP holdtime in seconds for Cisco routers?

2 Answers  


1.i have to pcs in the network 192.168.1.1 202.55.88.16 2. if that fails shud go through 122.16.1.3 and and if that comes back active it shud go through 202.55.88.16 itself

1 Answers  


What 3 sources can configuration commands be placed into RAM? A.) HP Openview B.) Console C.) Vterminal D.) TFTP server E.) NVRAM

1 Answers  


What are two functions of the ICMP protocol? (Choose two) A. to map IP addresses to Ethernet addresses B. to map common names to network addresses C. to forward SNMP alerts to management consoles D. to generate an echo reply in response to a ping test E. to send a host or pod unreachable message from a router to the source of an undeliverable packet

1 Answers  


What is the subnetmask of / 27 in network based and host based?

0 Answers  


Categories