What is the default interval for SAP updates?
A.) 60 seconds
B.) 15 seconds
C.) 30 seconds
D.) 120 seconds
Answer / guest
Answer: A
By default, the SAP (Service Access Protocol) sends out
updates every 60
seconds. This value can be changed to alter the update
interval. To
decrease WAN traffic, the update interval could be increased
to every 5
minutes.
| Is This Answer Correct ? | 8 Yes | 1 No |
Which IP address and wildcard mask would you use in your ACL to block all the hosts in the subnet 192.168.16.43/28?
Why is UDP lease favored when compared to TCP?
A network is vow congested currently all the devices are connected through a hub. Which would best decrease congestion on this network? A. add a second hub B. replace the hub with a router C. replace the hub with a switch D. replace the hub with a repeater
Suppose a Switch interface went in error-dis mode what you will do for Troubleshooting List all Possibilities
Name the command we give for see routing table?
Differentiate between broadcast domain and collision domain
Which Distance Vector characteristic can help to speed up convergence? A.) Triggered Updates. B.) Split Horizon. C.) Poison Reverse. D.) Hold Down timers. E.) Inverse ARP.
Explain the draw back of eigrp protocol?
What is the update period for rip?
Given the global configuration commands: 'banner motd #' 'Hello #' When would the message be displayed? A.) The message of the day banner shows up before login. B.) The message of the day banner shows up during logoff. C.) These commands are not the right syntax for MOTD. D.) Message of the day banners are displayed upon entering global config mode. E.) Message of the day banners are not possible. F.) The message of the day would be, 'Hello #'
What is matric?
Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses