Answer / guest

Answer: B

The two types of Frame relay encapsulation are Cisco and IETF.

here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.

3 Answers  

---

Which of the following is true regarding standard ISDN BRI service? A.) ISDN BRI B channels are typically 64K. B.) ISDN BRI can handle only voice. C.) ISDN BRI can handle only data. D.) ISDN BRI has 2B and 1D channels. E.) ISDN BRI D channels are 16K. F.) ISDN BRI can handle voice and data.

2 Answers  

---

What is convergence time? A.) The update time B.) The time it takes to reload a router C.) The time it takes for a packet to reach its destination D.) The time is takes for all routers update their tables after a change takes place

1 Answers  

---

what is different between cisco router and layer 3 switch

8 Answers   Cisco, LABA Nepal,

---

Of the following characteristics, which apply to UDP? Connection-oriented Connectionless Error checking Low overhead Best-effort delivery

5 Answers  

---

How many types of ends in wan?

0 Answers  

---

Identify IPX SAP and it's purpose? A.) Sonet Access Pipe - interface to Sonet ring B.) Service Advertising Protocol - advertise services C.) Server Appletalk Protocol - appletalk directory services D.) Service Access Point - identify upper layer protocols

1 Answers  

---

Identify the command mode necessary to enter the standard ping command? A.) Router(config)# B.) Router> C.) Router(std-ping)# D.) Router(config-if)#

2 Answers  

---

For IPX, what is the DEFAULT Cisco Encapsulation on an Ethernet interface? A.) novell-ether B.) gns C.) snap D.) arpa E.) sap F.) dix

1 Answers  

---

Based on the DR AND BDR discussion i want to put one question the question is what is the name of protocol which is responsible;e for DR and BDR selection

7 Answers   Patni,

---

Which two statements are true? (Choose two) A. Ethernet 802.3 utilizes a half duplex method for data transfer B. In a 100 MBS point to point connection a full duplex connection can provide 400 Mbs of data transfer C. Ethernet switches can use the full duplex mode to connect multiple nodes on a single pod of a switch D. Full duplex Ethernet takes advantage of UTP using one pair for transmission and the other pair for reception

1 Answers  

---

In version 11.2 of the IOS, a Cisco router configured for frame-relay can automatically detect the LMI type. What is this known as? A.) Psychic B.) ESP C.) Inverse ARP D.) Hello E.) Reverse ARP F.) Autosense

2 Answers  

---