Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following protocols are used for logical network
addressing?
A.) IP
B.) TCP
C.) ARP
D.) ICMP
E.) RARP
F.) BootP
- 5 Answers
- 7108 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / m haja bahurudeen
ANS : A
Protocol Used in layer
IP - L3
TCP - L4
ICMP - L4
ARP - L3
RARP - L3
BootP - L7
| Is This Answer Correct ? | 3 Yes | 1 No |
HI ALL , wanted to know if the rstp protocol.. rapid spanning tree protocol .. is imp to study with ccna's point of view or study of STP will be enough.. in some books rstp is nt given like todd lamle however in icnd2 its explained in detail.. please suggest asap .. thanks ..
What is the bandwidth capacity of one ISDN B channel A. 64 kbps B. 128 kbps C. 512 kbps D. 1.54 mkbps
Which IP packet field will prevent endless loops? type-of-service identificationf lags time-to-live header checksum
What is the difference between TCP and UDP? A.) TCP is connection-oriented; UDP uses acknowledgements only B.) TCP is connection-oriented; UDP is connectionless C.) Both TCP and UDP are connection-oriented, but only TCP uses windowing D.) TCP and UDP both have sequencing, but UDP is connectionless
Hi all, Sorry, but i want to say that right now i have around two years experience and doing the job as a network engineer(ccna certified).but i want switch job so please can tell me any opportunity.
Given the following output, how can we close Telnet session 2? (Choose two) CCNA2620#show sessions Conn Host Address Idle Conn Name 1 131.108.100.152 131.108.100.152 0 131.108.100.152 *2 126.102.57.63 126.102.57.63 0 126.102.57.63 ❍ A. Press the Enter key and enter exit. ❍ B. Enter disconnect 2. ❍ C. Press the Enter key and enter disconnect 2. ❍ D. Enter close 2.
Which layer is responsible for synchronizing sending and receiving applications? A.) Presentation B.) Session C.) Transport D.) Application E.) Network
Name the protocol which can do load balancing on unequal cost also?
What is the IEEE specification for Spanning Tree Protocol? A.) 802.9 B.) 803.ud C.) 803 D.) 802.1d
When you use the Cisco IOS command show configuration on a router which part of the output shows the specific conferred IP addresses and shored masks? A. the IP host table B. the interfaces output C. each section of the output D. the global configuration statements E. the section under the autonomous system number
Can Anybody tell me if I wanna block all MP3,video sites from cisco 2600 router,how shall i proceed with ACL's?? Please post the steps for the following alonge with detail. Thanks to you all ..appriciated
hi friend i am stuck in the big problem.this problem is regading pix firewall. i have a cisco pix 515e firewall inmy company.now when i configure it and after rebooting it the ACT link never getup.when i apply clear config all comand the ACT link get up after oveservation i see that there is fauilover problem when i apply failover active ACT link agin get up is there any way to get my firewall in standby mode rember that there is only on firewall within my n/w i am lookig towards all of you jitendera kumar sinha
CCNA 
