Which commands will restart the router?
A.) router#system exit
B.) router >reload
C.) router#shutdown
D.) router#reload
E.) router#(config)reload
F.) router#system restart
Answers were Sorted based on User's Feedback
Answer / kumar
reload command will be given in previlleged mode not in the
user mode.
| Is This Answer Correct ? | 18 Yes | 7 No |
The following selections show the command prompt and the configuration of the IP network mask. Which two are correct? A. Router#term IP netmask-format { bitcount | decimal | hexadecimal } B. Router(config-if)#IP netmask-format { bitcount | decimal | hexadecimal } C. Router(config-if)#netmask-format { bitcount | decimal | hexadecimal } D. Router#ip netmask-format { bitcount | decimal | hexadecimal }
What is the updates time of routing table,and what is the invalid timer, and also what is the flush timer in IGRP and EIGRP?
How many types of nat?
If you are running Token Ring with Novell IPX routing, which encapsulation should you use? A.) SAP B.) SNAP C.) 802.5 D.) 802.2
What are the Timer of RIP, IGRP, EIGRP and OSPF Routing Protocol?
How often does IP RIP send out routing table updates by default? A.) They send complete updates every 30 seconds B.) They send partial updates every 30 seconds C.) They send complete updates every 60 seconds D.) They send partial updates every 60 seconds
What does a router do with a packet that it does not have a destination network for? A.) Sends it to the Serial port B.) Drops the packet C.) Sends it back out the same interface it received it in D.) Forwards the packet to the next hop
What are characteristics of UDP A. It is reliable and acknowledged B. It is unreliable and acknowledged C. It is reliable and unacknowledged D. It is unreliable and unacknowledged
What is the syntax to add a banner to the Cisco router? A.) motd banner # B.) banner C.) banner motd # D.) banner #
Whith the hierarchical numbering of IP addressing what determines the spoon of the address that will identify the network number? A. subnet mask B. dots between octets C. class of the first octet D. assignments of DHCP E. address resolution process
In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to NVRAM before becoming enabled
Explain what is eigrp?