Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
2198We all have seen transmission and Distribution lines In transmission lines the voltage is high and current is low(to reduce I^2r loss) and in distribution lines voltage is low but current is high however the size of transmission wires is bigger than that of distribution wires even though the amount of current carried by the distribution lines is more than that of transmission lines why?
4 6815Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
ARDE,
2091in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
1879Post New Electrical Engineering Questions
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
where solid grounding and where grounding through ngr done and why?
what is the star delta connetion and how can do it a three phase motor with control witing with picture
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
What are hrc fuses and where it is used?
l&t switch FN 63 handle position can we change
condition Autotrip facia come on control panel of electrical transmission line?
what is the difference between pvc & fiber glass cables
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
explain PV modules in solar energy generation.
What is the differentional relay...what is the work of this in power Tx. how it is works..
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
A d.c. Shunt motor is found suitable to drive fans because they require?
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?