If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????1005
If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?1226
How to conduct a Hipot test on a 11KV cable?2 16859
in ct secondary one terminal is connected to earth why?1 1403
what is Different between Bilinear and Unilenier?
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not1188
What it the purpose of parallel phasing transfomers??1046
What is the power ratio between power in Star and Delta circuit?3 2658
What is the difference between earth and neutral3 3749
What is the difference between Earthing & grounding4 5982
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?1171
WHAT IS THE WINDING PROCEDURE OF ELECTRICAL MOTOR
i've iocl interview.. if you know the interview process please give me information..
Why we are use dol starter up to 10 hp
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
how many types of motor can be used in washing machine
Why cables and busbar both needed in LT Panels?
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
do we use links in a dc circuit?if so what s its use in it?
block diagram of 2 ups system connected in hot stand by mode?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
what is the requirement regarding earthing of Single conductor with AWA
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.