can motors working at parallel operation like D.G set and transformers? It means asking about two motors coupled with same load???
1 3894In a 3Ph induction motor(old) 6 wires came out from terminal & not mentioned u1,v1,w1,u2,v2 & w2. how can find out the terminals? how can connect to star delta starter??
1 10870sir i used 3 hp of motor for spraying pump, other home light and other home items which size of allminium pvc wire ix used
1849in a transmission line if the load is suddenly increased in the receiving end of the system the phase shift will ?
1 8537Post New Electrical Engineering Questions
explain comutator action in detail.thanks
how to remover corona effect and hysteresis losses from contactor
What is hipot test procedure?
what is static frequency converter?what is the function...of sfc...?
How many types are using in 220kv/400 kv swith yard
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
How LT megger works ?
What is creepage distance..... what will be the value for different voltage level
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
why and how current drawn by battery charger depends upon the altitude where it is located?
what ispositive, negative, zero sequence impedence?
how to maintain frenquncy with syncronising sub-station for distribution
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.