what is the basis for selection of Protection CT class ? How anyone can decide whether to go for 5P10 or 5P20 ?
3 5325I am final year b.tech student..i applied for gate but i am not interested any of my engineering subjects. i am interested in management wise.. is my option correct after b.tech..
1 2837Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks
1460IN A DY11 GROUP DISTRIBUTION TRANSFORMER WITH NEUTRAL EARTHED, WHAT WILL HAPPEN TO THE SYSTEM VOLTAGE & THE EQUIPMENTS IF EARTH GETS OPEN ON LOAD?
2 4885my UPS is 600VA with 0.6 p.f and i use it for my computer which has 450W power supply unit, a monitor of 633nW and speakers. Can any one explain this.. because the output of UPS should be 360W (<450W)
2 4310I have been using an 600VA with 0.6 p.f UPS with my desktop which has 450W power supply unit. Can anyone explain how can this happen . Because the output of the UPS is 360W (600*0.6) (<450W)
1662Post New Electrical Engineering Questions
What is the purpose of stablization resistor in high impedance bus bar protection
what is the function of capacitor duty contactor in an capacitor panel???
Why have to use copper cable for local isolator to motor ?
What Maximam Gap Taibaar & Bush
What is the function of RCBO? What are the different sensitivity ratings & each application?
What is the maximum percentage voltage drop (vd%)for a motor control center
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
HOW WORK HEAT PLATE EXCHANGER
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
Please elaborate th´evenin’s theorem?
I am completed DEEE in tamilnadu, now i am working in andhrapradesh with 2.5 year experience in relavent field. capacity of the tranformer is 11KV, 1MVA Transformer, i am eligible for getting c licence in andhrapradesh pl help me.
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?
how to calculate single phase motor efficiency ?