why VCB always installed only at HT yards or HT side? suppose if ACB installed at there means, what will be problem?
1 7461what time should we set to come on star contacter in stardelta starter?and for what reason we hav to set such time delay range?
2 5466What type of input will the OLTC indicator will accept or what type of output the OLTC will produce to monitor it's position at remote location.
amps,
1 3996What is the minimum setting in REF relay because i am facing some problem whenever power resumes after power failure my transformer is tripping because of REF trip. I am using CSPC make numerical relay(DIP switches). Now setting is 15 percentage. What is the reason for this triping. I sm waiting for answer
2 4976when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
2043Post New Electrical Engineering Questions
What is A check, B check, C Check & D check for a diesel Generat
during installation time of transformer and alternator which points we have to observed?
What is the breaking capacity of transformer and how can we calculate the breaking capacity of tranformer
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
What is online and offline ups? how does it works?
What is the dependency of stiffness on load angle??
What are the types of excitation system?
1 hp is equal to how much watt?
why single phase to grd test in HV cable?why not 2 phase at a time?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
wheather the size of windings in motor and generator are the same