fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
NIC,
1063A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
1235What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
HPCL,
1097A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
TCS,
1065Post New Electrical Engineering Questions
Define de-sensitivity?
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
How will polarity test of Dy5 Transformer ?
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
internally connection of photvoltic module
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
Electrical Engineering
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
why h parameter are called as hybrid parameter?
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
why on axial hitting up of air blast on hydrogen produced in oil circuit breaker,temperature rises of the core of the arc?