want to know all about inerview of dmrc for je(mech.)
want to drdo paper for the post of tech.asstt.(mech)
unit of tensile strength12 19734
for a multi storey building how to control the flow of water in each floors2 2516
Where is the maximum temperature in refrigeration cycle? a.Between evaporator & compressor. b.At Compressor c.Between compressor and condensor. d.At condensor
The capacity of the compressor is considered to be maximum when the temperature of the air is a.Maximum b.minimum c.moderate d.10 6255
What are carvings in Ajanta Caves? a.Mahabarath b.Ramayana c.Jataka Tales d.Upanishads1 4366
i am P.SURESH(B.Tech-Mechanical) i need previous ouestion papers of NHPC-National Hydroelectric Power Corporation Limited,please get me.1 3037
longest river in world3 4089
what is gear8 5782
what is synchronizer2 5211
What is a feasibility study?
What does Nominal size in a valve means like NG6,NG10 etc
Which welding process uses non-consumable electrodes?
What is method to calculate the noise level at any point of duct if duct dimensions and air flow is known?
T union support factor
Dear Friends I want to previous 5-10 years technical and non tech. question paper of section engineer (mechanical)of RRB and also tell me how should I prepare for S.E. and which books will help me for technical,aptitude,resoning.plz send me at email@example.com
how does the lybrinth glands work in sealing a turbine? how exactly turbine sealing is done? principle of it?
Explain how can I see where pipes are behind the wall?
Which pipe should I use SAW, ERW or seamless if I have the following constraints I have to transport methane gas Size is 8” Corrosive environment Sulphide is present Also tell the cost comparison
What causes diesel engine to automatically stop?
sir,iam applied rrb chennai for the post of junier engineer,i need objective type question book,please refer the suitable book,author and publication.
What is a turboprop engine?
How do you convert feet into square feet?
What are the disadvantages of axial flow (piston type) automatic control valve compared to the conventional types (globe or diaphragm) If you are a designer/specifier, do you accept this type of valve for using in building's piping systems ?
Which are the sheets of metals?