what is the difference between transformer welding machine and rectifier welding machine?2 15113
What would you like to do?1 1884
In a class, there are 15 boys and 10 girls. Three students are selected at random. The probability that 1 girl and 2 boys are selected, is:2 9346
y we are used oil in the dead weight pressure tester1 1073
how do you differentiate the while look at drawing whether it is first angle or third angle projection.2 3874
WHY DO DEAD BODIES SAIL ON WATER WHERE AS A HUMAN BEING GET DROWNED?1 2611
what is the stanton curve?1487
How will you measure the eccentricity of the turbine rotor during running1981
Hi! Greetings of the day. Can somebody tell me about as built duct sheet area calculation method. As we know that for this purpose A = (W+H)*2*L. But I have query about multiplication factors for elbows, tappers, offsets etc if there is any. Also refer the papers if available. Please revert. Thanks in advance.894
what are the groups of instruments?
What causes damage to impellers?
can a deareator be placed at any height with care that suction (NPSH) for feed pump is satisfied
What is the ratio of specific heat of air?
What is the microstructure content of D25-8 nodular cast iron?
What is the difference between torque and power?
Where can you find space heater lam p and what is its purpose?
What is volumatric air change of a HOT GAS GENERATOR of a STEAM BOILER ?
What is a time and motion theory?
What is view factor ?
How fast is a jet plane?
DOES IS 2062 SPECIFIES ONLY SEAMLESS PIPES OR ERW PIPE IS ALSO COVERED UNDER IS 2062
Which two elements have same percentage in proximate and ultimate analysis of coal?
what is the thickness tolerances up to 32 mm
i am from karnataka can i able to apply appsc