What is the distance limitation for 100BaseT? A. 305.955 ft B. 7283.46 inches C. 184 Meters D. 185 Kilometers

What is the distance limitation for 100BaseT? A. 607 ft B. 25 Meters C. 1,000 ft D. 185 Meters

A network is vow congested currently all the devices are connected through a hub. Which would best decrease congestion on this network? A. add a second hub B. replace the hub with a router C. replace the hub with a switch D. replace the hub with a repeater

Which command should you use to confound a router so that it can become a TFTP server host for a router system image that is run in a Flash? A. copy flash tftp B. config tftp server C. write, network -router name- D. tftp-server system -file name- E. setup server tftp -system name-

Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash tftp D. copy tftp flash

In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to PAVRAM before becoming enabled

What not a name of an ISP? A. MSN B. Comcast C. Verizon D. McDonalds

How does inter- VLAN communication take place? A. It takes place through any Cisco router B. It takes place through a Cisco router that can run ISL C. It takes place through a router but this disables all the router a security and filtering functionality for the VLANS D. For nonroutable protocals (e.g. NetBeui) the router provides communications between VLAN domains E. Inter-VLAN communication is not possible because each VLAN is a separate broadcast domain

Which technology is used by Catalyst switches to resolve topology loops and ensure data flows properly through a single network path? A. virtual LANS (VLANS) B. frame filtering C. cut-through switching D. spanning-tree protocol

Which two statements about IP RIP are true? (Choose two) A. It limits hop counts to 31 B. It is a link state routing protocol C. It uses autonomous system numbers D. It is capable of load sharing over multiple paths E. It uses bandwidth as the metric for path selection F. It broadcasts updates every 30 seconds by default

What are two purposes for segmenting a network with a bridge? (Choose two) A. to reduce collisions B. to increase collisions C. to add collision domains D. to reduce collision domains E. to have more broadcast domains

Ecobank, RNP,

What is the protocol and what is the purpose of the following address? 238 255 255 255 A. IPX a SAP broadcast B. IP a multicast group C. IP a reserved address D. IP a directed broadcast E. IPX a flooded broadcast

Which of the following is true? A. The default is to send debug output to the console screen. B. To view debug output from a telnet session, the "terminal monitor" command must be used C. If the "logging buffered" command is used, the debug output would be sent to RAM and can be viewed with the "show log" command D. If the "no console loggin" command were configured, output would besent to a telnet session E. All of the above F. None of the above G. A, B, and C. H. A, C, D, and E.

What is the maximum number of subnets that can be assigned to networks when using the address 172.16.0.0 with a subnet mask of 255.255.240.0? (Assume older version UNIX workstations are in use.) A. 16 B. 32 C. 30 D. 14 E. It is an invalid subnet mask for the Network.

How many total hosts are possible with a Class C address and a subnet mask of 255.255.255.252? A. 4 B. 30 C. 60 D. 62 E. 112 F. 124