What command displays detail information about the OSPF interfaces, including the authentication method?
1 6225What command displays the OSPF Process ID, Router ID, Address summarizations, Routing Networks, and passive interfaces configured on a router?
1 8933What command displays a summary list of OSPF interfaces that includes a column for the cost of each interface?
1 9305which device/card is used at the end of computer/device to connect multiple or different wire of mesh topology to a single computer/device?
1 2941When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?
948
Tell me how much hold down time of eigrep protocol?
Explain the benefits of vlan?
What is loop back ip in ipv6?
Suppose we are having two Switches i.e. Switch1 & Switch2 Port1 of Switch1 is Connected to Uplink and switch2 is also connected to switch1? So 1>Is there is any loop? 2>How we come to know that there is a loop created? 3>If we add Switch3 to switch2 then there is a possibility of loop Creation?
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
When we do default route?
Why is vlan used?
What is the purpose of the Data Link?
Explain the difference between tftp and ftp application layer protocols?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router router?
Which type of transmission bus topology support?
What are the ranges for the private ips?
What are the things that can be accessed in a CISCO router’s identifying information?
What is the mac address?
What are the advantages of using switches?