Interested to Buy Any Domain ? << Click Here >> for more details...
What is the IEEE specification for Spanning Tree Protocol? A.) 802.9 B.) 803.ud C.) 803 D.) 802.1d
1 4079CO is an acronym for which of the following? A.) Central Office B.) Capital Office C.) Central Operator D.) Company Office
1 4293What is convergence time? A.) The update time B.) The time it takes to reload a router C.) The time it takes for a packet to reach its destination D.) The time is takes for all routers update their tables after a change takes place
1 4170Which of the following are Session Layer standards? A.) ASCII and EBCDIC B.) MPEG and MIDI C.) RPC and SQL D.) JPEG and PICT
3 7517Define Poison Reverse? A.) To prevent regular update messages from reinstating a route that has gone down B.) Packets sent out that are not destined for a network go to the default network C.) Information received on an interface cannot be sent back out the same interface D.) When a network goes down, that network is advertised with an infinite metric
1 5340What is the default interval for SAP updates? A.) 60 seconds B.) 15 seconds C.) 30 seconds D.) 120 seconds
1 4323What does a router do with a packet that it does not have a destination network for? A.) Sends it to the Serial port B.) Drops the packet C.) Sends it back out the same interface it received it in D.) Forwards the packet to the next hop
1 5449What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II
1 4138Which protocol is used for booting diskless workstations? A.) IP B.) ARP C.) RARP D.) TCP E.) SNMP
3 16471Which layer is responsible for synchronizing sending and receiving applications? A.) Presentation B.) Session C.) Transport D.) Application E.) Network
1 4571Which protocol gets a hardware address from a known IP address? A.) RARP B.) TCP C.) IP D.) BootP E.) ARP F.) ICMP
3 8385Which layer defines bit synchronization? A.) Application B.) Network C.) Transport D.) Physical E.) Session F.) Session
2 10465Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end B.) Half duplex transmission between stations is achieved by using point to multipoint Ethernet and Fast Ethernet C.) With Half Duplex transmission logically circuits feed into a single cable creating a situation similar to a one way bridge D.) Half Duplex transmission between stations is achieved using Point to Point Ethernet & Fast Ethernet
2 5511When would you use ISDN? A.) To connect LANs using POTS B.) To support applications requiring voice, data, and video C.) When you need a consistent and very high rate of data speed D.) To connect to IBM mainframes
2 5228
What is the maximum request timer?
Does a bridge divides a network into smaller segments?
What is the difference between the communication and transmission?
What is the difference between full duplex and half duplex?
How do we do encryption and authentication in L2F?
Tell me which protocol called rapid protocol?
Explain the difference between named and extended acl?
What are the steps of data encapsulation?
What s the formula for metric of ospf?
what does PPTP use for encryption and authentication?
How many types of nat?
Name the protocol which can do load balancing on unequal cost also?
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
If there is only 2 host in bus topology is that possible collision accord?
Which command we give for live view of remote site routers?
