Answer / guest

Answer: C

Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom

1 Answers  

---

You want to set the console password to ralph. What would be the first command you need to execute from global configuration mode? A.) line console 0 B.) enable password ralph C.) login password ralph D.) set password= ralph E.) password ralph F.) login Ralph

1 Answers  

---

What is fcs?

0 Answers  

---

What are the three sources of signal degradation on a data link?

0 Answers  

---

Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay

1 Answers  

---

Hi, I am littl bit confused about ip Addressing scheme? can someone tell me how can we assign ip addresses to pc

2 Answers  

---

what is difference between packet switching and circuit swtching

0 Answers   ASD Lab,

---

Can you define in short what VPN is?

5 Answers   CCIE,

---

What are the different types of the password used in securing a cisco router?

0 Answers  

---

Does a bridge divides a network into smaller segments?

0 Answers  

---

For IPX, what is the DEFAULT Cisco Encapsulation on an Ethernet interface? A.) novell-ether B.) gns C.) snap D.) arpa E.) sap F.) dix

1 Answers  

---

What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network

1 Answers  

---